Using Floor Joist For Cold Air Return

Plan your cold air return ducts to fit comfortably in this area.

Using floor joist for cold air return.

This is an appropriate use for space that cannot be used for actual heating and air conditioning. This article addresses the issue of unsealed wall stud cavities or panned floor joists used as a return air plenum resulting in risks such as indoor air quality issues due to negatively pressurized cavities drawing air through cracks along with any contaminants and also condensation by drawing in warm humid air. All the duct work for heat uses 5 and 6 inch pipes which is fine and makes no noise. Did that cause problems.

The photo below shows some of the joists in the vented crawl space that the basement was completely connected to. It is impossible to create an airtight seal with this method and together with the negative pressure that is created inside the cavity air leakage occurs through joints of the rim at the end of. I have a new house and have a question. Hallways as part of a return air system.

Most prefer rigid to flex since flex creates too much resistance and decreases airflow. Panned floor joist are a commonly utilized as return ducts by nailing gypsum board foil insulation osb flooring panels or sheet metal to the joists. All my cold air returns use the space between the joists with sheet metal screwed against the joists. John here using the joists as a return is common practice if it is inside the envelope conditioned space.

Using floor joists as return ducts by panning can cause leakage because negative pressure in the cavity will draw air from the outside into the cavity through the construction joints of the rim area at the end of the joist cavity. Homes with basements often use wall studs and floor joist spaces as return air cavities. These sheets of metal make constant noise when we walk on the floor above the return duct. For example an 8 by 14 inch rectangular duct will fit between 2 by 10 floor joists installed 16 inches apart on center.

The space between the floor joists may be used as part of the return duct system. If the return lies outside of the envelope insulated rigid or flex ducting is mandatory. Corrective measures are also suggested.